H3c-technologies H3C WA3600 Series Access Points Manual do Utilizador descarregar pdf (Página 16)

Figure 10 T-rail holder

(1) T-rail clip (2)

screw nut

(3)

Clip holder

(4) T-rail holder (5)

screw nut

(6)

M4 × 8 screw

(7) M3 × 6 screw (8) Mounting hook

To mount the AP to a ceiling T-rail:

1. Loosen the two M3 × 6 screws on each clip holder just enough (do not remove the screws or they

may get lost).

2. Adjust the T-rail clips to make the T-rail holder wider than the T-rail. See callout 1 in Figure 11. Then

lock the T-rail with the T-rail holder according to the arrow indicated in callout 2 in Figure 11.

Figure 11 Fix the T-rail holder to the T-rail

3. Tighten the four M3 × 6 screws on the two clip holders until the screw heads touch the T-rail, and

then fix the screws.

4. Check whether the T-rail holder is fixed to the T-rail.

5. Hook the mounting clip (see callout 5 in Figure 12) of the wall-mounting bracket to the mounting

hook (see callout 4 in Figure 12) of the

T-rail holder.

6. Insert the two M4 × 8 screws (see callout 1 in Figure 12) through the two 5 mm (0.20 in) diameter

holes on the wall-mounting bracket according to the dashed line shown in Figure 12 and fix the

rews to the T-rail holder.

7. Check whether the wall-mounting bracket is fixed to the T-rail.

8. Connect the AP to the network by using an Ethernet cable.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Sem comentários

H3c-technologies H3C WA3600 Series Access Points Manual do Utilizador Página 16