H3c-technologies H3C WA3600 Series Access Points Manual do Utilizador descarregar pdf (Página 301)

100

101

288

Item Descri

tion

STP

The following loop types may exist in a WDS network:

.When a loop exists in the network, you can block redundant links to

remove the loop by STP, and can provide link backup when a WDS

link fails.

Set STP.

• Enable—Enable STP.

• Disable—Disable STP.

By default, STP is enabled.

This configuration is applicable to only WLAN-mesh interfaces, and

global STP configuration (see "Configuring global WDS") i

applicable to all interfaces.

Link Maximum Number

Set the maximum number of WDS links allowed.

IMPORTANT:

If an AP needs to establish more than two WDS links, you must set this

number as required.

Link Hold RSSI

Set the link hold RSSI.

This is the minimum RSSI required to establish and hold a link.

Therefore, the minimum RSSI must be ensured. Otherwise, the error

rate can be very high and the link performance deteriorates.

ratemode

• fixed—The rate adopted is of a fixed value. It is the maximum rate

of the current radio.

• realtime—The rate adopted changes with the link quality, that is,

the rate changes with the change of the RSSI of the current radio.

The fixed mode is adopted by default.

1 2 ... 296 297 298 299 300 301 302 303 304 305 306 ... 446 447

Comentários a estes Manuais

Sem comentários

H3c-technologies H3C WA3600 Series Access Points Manual do Utilizador Página 301

Comentários a estes Manuais