H3c-technologies H3C SecPath F5020 Manual do Utilizador descarregar pdf (Página 29)

Ste

Command

Remarks

10. Set the MTU for the dialer

interface

mtu size

By default, the MTU on a dialer

interface is 1500 bytes.

The dialer interface fragments a packet

that exceeds the configured MTU, and

adds a 2-byte PPP header and a 6-byte

PPPoE header to each fragment. You

should modify the MTU of a dialer

interface to make sure the total length

of any fragment packet is less than the

MTU of the physical interface.

Configuring a PPPoE session

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter Layer 3 Ethernet

interface/subinterface, Layer 3

virtual Ethernet

interface/subinterface, VLAN

interface, or WLAN Ethernet

interface view.

interface interface-type

interface-number

N/A

3. Create a PPPoE session and specify a

dialer bundle for the session.

pppoe-client dial-bundle-number

number [ no-hostuniq ]

By default, no PPPoE

sessions are created.

The number argument in this

command must take the

same value as the

configured dialer interface

number.

Resetting a PPPoE session

After you reset a PPPoE session in permanent mode, the device establishes a new PPPoE session when the

autodial timer expires.

After you reset a PPPoE session in on-demand mode, the device establishes a new PPPoE session when

there is a demand for data transmission.

To reset a PPPoE session:

Ste

Command

Remarks

1. Reset a PPPoE session.

reset pppoe-client { all |

dial-bundle-number number }

Available in user view.

Displaying and maintaining PPPoE client

Execute display commands in any view and reset commands in user view.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Comentários a estes Manuais

Sem comentários

H3c-technologies H3C SecPath F5020 Manual do Utilizador Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Segurança H3c-technologies H3C SecPath F5020