H3c-technologies H3C S3100V2 Series Switches Manual do Utilizador descarregar pdf (Página 98)

Figure 28 Network diagram for IPv6 multicast source/user control policy configuration

Configuration procedures

1. Configure IP addresses for interfaces

Enable IPv6 forwarding and configure an IP address and prefix length for each interface according to

Figure 28.

The configuration steps are omitted here.

2. Configure Switch A

# Create VLAN 101 through VLAN 104 and assign Ethernet 1/0/1 through Ethernet 1/0/4 to the four

VLANs respectively.

<SwitchA> system-view

[SwitchA] vlan 101

[SwitchA-vlan101] port ethernet 1/0/1

[SwitchA-vlan101] quit

[SwitchA] vlan 102

[SwitchA-vlan102] port ethernet 1/0/2

[SwitchA-vlan102] quit

[SwitchA] vlan 103

[SwitchA-vlan103] port ethernet 1/0/3

[SwitchA-vlan103] quit

[SwitchA] vlan 104

[SwitchA-vlan104] port ethernet 1/0/4

[SwitchA-vlan104] quit

# Enable IPv6 multicast routing. Enable IPv6 PIM-DM on VLAN-interface 101, VLAN-interface 102 and

VLAN-interface 104, and enable MLD on VLAN-interface 104.

[SwitchA] multicast ipv6 routing-enable

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] pim ipv6 dm

[SwitchA-Vlan-interface101] quit

[SwitchA] interface vlan-interface 102

[SwitchA-Vlan-interface102] pim ipv6 dm

[SwitchA-Vlan-interface102] quit

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 110 111

Sem comentários

H3c-technologies H3C S3100V2 Series Switches Manual do Utilizador Página 98