H3c-technologies H3C SR6600-X Manual do Utilizador descarregar pdf (Página 43)

Interface specifications

Table 37 Interface specifications

Item S

ecification

Connector type RJ-45

Number of interfaces 1

Interface standard

• G.703/T1 102

• G.704

• AT&T TR 54016

• AT&T TR 62411

• ANSI T1.403

Interface speed 1.544 Mbps

Interface cable type 8T1 splitter cable

Working modes

• CT1 (supported by the MIM-8T1)

• FT1 (supported by the MIM-8T1-F)

Services supported

• Backup

• Terminal access service

LEDs

Table 38 LED description

LED Status Descri

tion

LINK/ACT

(Green)

Off No carrier signals are being received.

On Carrier signals are being received.

Flashing Data is being transmitted or received.

LP/AL

(Yellow)

Off No loopback or alarms occur.

On The interface is in loopback state.

Flashing A minimum of one alarm of the type of AIS, LFA, or RAI occurs.

Interface cables

The MIM-8T1 or MIM-8T1-F provides eight T1 interfaces and uses an 8T1 splitter cable. At one end of this

cable is a DB-68 connector used to connect to the device, and at the other end are eight RJ-45 connectors

used to connect to the peer devices.

NOTE:

• The MIM-8T1/MIM-8T1-F does not support ISDN PRI.

• For the MIM-8T1, if you use the timeslot binding command on the controller T1 interface, the system

automatically creates the corresponding serial interface, on which you can make configurations. The

MIM-8T1-F does not have a controller T1 interface, and a physical interface corresponds to one and

only one serial interface, which is automatically created without the need of additional configuration.

• For the appearance and connection of a MIM-8T1/MIM-8T1-F interface cable, see "Connecting a T1

interface cable."

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 84 85

Comentários a estes Manuais

Sem comentários

H3c-technologies H3C SR6600-X Manual do Utilizador Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Routers H3c-technologies H3C SR6600-X