H3c-technologies H3C SecPath F5020 Manual do Utilizador descarregar pdf (Página 66)

Figure 20 Network diagram

Configuration procedure

1. Configure Device A:

# Assign member ID 1 to Device A, and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.

<Sysname> system-view

[Sysname] irf member 1

Info: Member ID change will take effect after the member reboots and operates in IRF

mode.

[Sysname] irf-port 2

[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1

[Sysname-irf-port2] quit

# Save the configuration.

[Sysname] quit

<Sysname> save

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y

Do you want to convert the content of the next startup configuration file

flash:/startup.cfg to make it available in IRF mode? [Y/N]:y

Please wait...

Saving the converted configuration file to the main board succeeded.

Slot 1:

Saving the converted configuration file succeeded.

Now rebooting, please wait...

Device A becomes a one-chassis IRF fabric.

2. Configure Device B:

# Assign member ID 2 to Device B, and bind Ten-GigabitEthernet 3/0/1 to IRF-port 1.

<Sysname> system-view

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 81 82

Sem comentários

H3c-technologies H3C SecPath F5020 Manual do Utilizador Página 66