H3c-technologies H3C SecPath M9000 Series Manual do Utilizador descarregar pdf (Página 20)

Figure 9 Attaching cable management brackets to an M9006 gateway

(1) Place the cable management bracket against the installation position on the chassis

(2) Screw holes for installin

the cable mana

ement bracket

(3) Screws for attachin

the cable mana

ement bracket to the chassis

(4) Power cable management bracket

Installing mounting brackets

Before installing the gateway to the rack, install the mounting brackets to the chassis. Marks L and R are

printed inside the mounting brackets to distinguish between the left and right mounting brackets. To

install the mounting brackets, face the front of the gateway, and attach the left and right mounting

brackets to the two sides of the gateway, as shown in Figure 10.

Figure 10 Installing the

mounting brackets to an M9006 gateway

(1) Screws for attaching the mounting brackets to the chassis (2) Mounting brackets

(3) Si

nal cable mana

ement brackets

Installing air filters (optional)

Air filters are installed at the air inlet vents to prevent dust from entering the chassis. If you have ordered

air filters, install the air filters before mounting the gateway to the rack.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 97 98

Sem comentários

H3c-technologies H3C SecPath M9000 Series Manual do Utilizador Página 20