H3c-technologies H3C SecPath F100-C-EI Manual do Utilizador descarregar pdf (Página 46)

Installation Manual

H3C SecPath F100-C-EI Firewall

Chapter 4 Starting and Configuring

the Firewall

4-7

z The power source voltage meets the requirement of the

firewall.

z The console cable is correctly connected, the configuration

PC or console terminal is running, and the concerned

parameters have been set on it.

Warning:

Locate the emergency power switch in the equipment room before

powering on the firewall so that you can cut off the power immediately

in case of accident.

4.2.2 Powering On the Firewall

Turn on the power switch of the firewall.

4.2.3 Checking the Firewall

After the firewall is powered on, check the device to ensure that:

z The LEDs on the front panel of the chassis indicate the

normal working condition of the firewall. See

Table 1-2 on

page

1-5 for more information on LED state.

z The console terminal display is correct. After powering on

the firewall, you can see the startup interface on the console

terminal.

z After the Power-On Self-Test (POST), press Enter as

prompted. When “[H3C]” appears, you can proceed to

configure the firewall.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 78 79

Sem comentários

H3c-technologies H3C SecPath F100-C-EI Manual do Utilizador Página 46